The Phaser plug-in provides a variety of controls for adjusting plug-in parameters.
When Sync is enabled, the Phaser Rate control synchronizes to the Pro Tools session tempo. When Sync is disabled, you can set the Rate in milliseconds independently of the Pro Tools session tempo. The Sync button is lit when it is enabled.
When Sync is enabled, the Rate control lets you select a rhythmic subdivision or multiple of the beat for the Phaser Modulation Rate. Select from the following rhythmic values:
When Sync is disabled, the Rate control lets you the rate of the Phaser in independently of the Pro Tools session tempo.
The Depth control lets you adjust the depth of modulation, which in turn affects the amount of phasing applied to the audio signal.
The Feedback control feeds the output signal of Phaser back into the input, creating a resonant or singing tone in the phaser when set to its maximum.
The Mix control lets you adjust the Mix between the “wet” (effected) and “dry” (unprocessed) signal. 0% is all dry, and 100% is all wet, while 50% is an equal mix of both.
The Low Cut control lets you adjust the frequency of the Low Cut Filter in the phaser’s feedback loop. This can be useful for taming low frequency “thumping” at high feedback settings.